updates and additions to the wiki to keep translations consistent.
Hi, Im getting an error that says: "Value current_basal is out of hard limits 0.00 limited to 0.001" and loop refuses to run, can someone help me?
@yiyoMX check your profile, sounds libre toy have basal set to 0?
Hi @viq, what do you mean with libre toy?
Argh, auto correct strikes again. "Sounds like you have basal set to 0"
@viq on the app or on the pump? because sometimes AAPS sets the basal to 0....
it's not about temporary basal but AAPS is complaining regarding base basal rate set to 0
Hi, I'm building on a Mac. All done except I don't have an 'OpenLoop' option (which is the one I want). I only have these options: fullDebug fullRelease nsclient2Debug nsclient2Release nsclientDebug nsclientRelease pumpcontrolDebug pumpcontrolRelease
It might be a good idea to add the step to restart to the wiki. Personally I spent quite some time figuring out if I did something wrong while it was a very easy fix.
There is no need to restart Android Studio.
If you follow the steps on the wiki everything should be fine. Otherwise look at the troubleshooting section for solutions to several issues which came up occasionally
I've installed android studio and tried to import project from gradle. It gets to configure build and then errors with something not in the guide "ERROR: There are uncommitted changes or git system is not available. Clone sources again as described in wiki and do not allow gradle update" I'm not sure how to not allow gradle update. Any help appreciated.
go to FB page for this kind of support
@danamlewis Is there a reason why you started with mostly markdown (.md) files instead of ReStructuredText (.rst). Just asking, because RTD recommends .rst
Might’ve been what we had used originally, and I think rtd also had some limited formatting options for rst in the beginning - this may have improved since then?
Hola buenas, estoy intentando montar APK y tengo problemas con Android Studio 3.5. ¿con que version se recomienda hacer? he probad con la ultima y no he podido. En informatica soy muy limitado, pero siguiendo los pasos que marca el tutorial tendria que funcionar. las pantallas tampoco son las mismas.
I'm brand new to androidaps. Can someone help me figure out how to show total daily dose of insulin. Also sometimes is will continue to deliver some basal below 85 and above 75. Is there a way to change the system low from 75 to something higher? Temp targets don't seem to matter in this scenario.
This is the wrong channel. Please use AndroidAPS channel or Facebook