These are chat archives for Makuna/NeoPixelBus

1st
Mar 2016
Wunder Baum
@wunderbaum
Mar 01 2016 07:42 UTC
Good morning!
Thanks again for your support.
Michael Miller
@Makuna
Mar 01 2016 07:43 UTC
Your welcome.
Wunder Baum
@wunderbaum
Mar 01 2016 07:43 UTC
So, I think for testing on the ESP is maybe good to do with bitbang method as the serial is often needed for debugging. When project is developped better, then change to dma.
Michael Miller
@Makuna
Mar 01 2016 07:45 UTC
Serial output or actual debugger? Serial output works fine with dma.
On 12e that is.
Wunder Baum
@wunderbaum
Mar 01 2016 07:46 UTC
Ah, I can use both? Serial output and dma for the led stripe?
Michael Miller
@Makuna
Mar 01 2016 07:47 UTC
Yes, I do it without a problem. Even the uart version uses a different uart than default serial
Wunder Baum
@wunderbaum
Mar 01 2016 07:48 UTC
Cool. I thought I can use one pin always for one purpose.
Michael Miller
@Makuna
Mar 01 2016 07:49 UTC
Which board do you have?
Wunder Baum
@wunderbaum
Mar 01 2016 07:53 UTC
esp12e
Michael Miller
@Makuna
Mar 01 2016 07:56 UTC
Serial output and programming are on txdo,rxd0, dma uses txd1
Sorry, dma uses rxdo, but it's used for output by neopixelbus, so it hasn't been a problem.
It's the uart version that uses txd1, so no problem there also.
Michael Miller
@Makuna
Mar 01 2016 08:01 UTC
(Had to pull out my cheat sheet, so many pin mappings)
Wunder Baum
@wunderbaum
Mar 01 2016 08:16 UTC
I will try when I am back home, I have nothing to loose :-)