These are chat archives for Makuna/NeoPixelBus

17th
Jun 2016
sticilface
@sticilface
Jun 17 2016 11:45
@Makuna got a question. is it possible to call serialswap before initiating neopixelbus using the DMA method, and to still have serial receive available on GPIO13?
unaiur
@unaiur
Jun 17 2016 11:46
UART1 can only transmit.
Serial1 uses UART1, TX pin is GPIO2. UART1 can not be used to receive data because normally it's RX pin is occupied for flash chip connection. To use Serial1, call Serial1.begin(baudrate).
Forget it.
I was wrong. Serial.swap changes pines not uarts
sticilface
@sticilface
Jun 17 2016 11:51
that is correct