Anyone avilabel??
Can you share oplink mini bootloader latest version
im getting only 2013 version
Please help
under "Bootloaders" sub-section
Oplink mini shows 2013
Its showing Linkstate Disabled
How to enable
@pfcoperez Please help
Hey everyone, I ported some old Allesio Morale's python scripts to the latest librepilot stable (16.09) and did some bugfixing. It works nicely (https://bitbucket.org/padeler/librepilot/branch/pyuavtalk_scripts). Is there any interest to merge it to the project? I could open a python-api related issue and create a pull request for that.
Hi @robertcasanova, next is of cause always a little bit experimental, but should be quite safe. Here's some more info on the arduino topic: https://librepilot.atlassian.net/wiki/display/LPDOC/Extend+a+Flightcontroller+with+an+Arduino
Hi @padeler we have an drone with cc3d where we have installed the librepilot 16.09 firmware. We try to read the telemetry data on our Raspberry Pi 3, which we have connected with the main port via the UART port of the pi. On the Rasperry pi we have run the example python script from the pyuavtalk_scripts branch. Unfortunately, we get a timeout during the connection step. Do you have any clue wat we are doing wrong? We have already checked that the serial ports are able to write and read data by connecting them to each other.
actually it would be nice to have more people flying next
than 'make mashu' to build your target, where of course mashu is not real board, replace it with what you want
than you can poke around the code
@mzzz1 for CC3D flashing is a bit more tricky, than for F3/F4 mcu boards, you will need uart-serial adapter, but you could also use SWD port on the board and flash/debug through it I suppose
@marvin521 correction, actually its on bitbucket ;) https://bitbucket.org/corvusvcorax/librepilot/src theres a lot of branches there with ancient code including the slam stuff
Would any of these work? https://www.u-blox.com/en/product-search/field_product_cellular_indus/unmanned-vehicle-456
Hi guys, I'm not sure this is the proper place to ask but it's the most appropriate I could find so point me onward if you can :) I'm building by first multirotor at the moment and am running into trouble with my understanding of it. I have a cc3d board to use on the device. When I configure the ESCs is it this board that does it or should I try do it manually? How do I program the cc3d such that it will hover and correct and all that?
hmm not much traffic here ;)
wonder where chat went
Last message was over a half year ago, seriously. Where else do you guys go? The IRC channel is also almost dead.
I got DJI GPS working with Libre Pilot, the latest version 16.09 r782 supports DJI Naza GPS natively and also supports NMIEA (9600 By default) on the revolution and works out of the box, fast and finding its satellites. However, my dilemma started while I had the connections taped together, I tried to make a custom cable and inadvertently shorted my Lumeneier vintage Revolution Open Pilot board (ordered a clone through China, 6 week delivery timeframe), it all worked beautifully in my TBS discovery. Do you know the color coding of the wires in the Naza GPS? I have red, blue, grey and the silver open wire (the ground or shielding?) I think I may have blown that too because I don't see a light come on. GPS. can I supply an kind of voltage to make it come on?
