Repetier-Firmware-0.92 based for DaVinci printer (alpha - ready for testing)
i dont quite understand what its asking
also the link of faq is in read me luc-github/Repetier-Firmware-4-Davinci#114
where are the due files on PC?
i should be able to figure it out now lol
i keep getting that error when i try to compile and upload to the davinci
does anyone know how to fix it?
so
i flashed it properly
a nd now i cant find the load firmware failsafe thing
the one that tells you to fix with 5999
*heater/sensor failure
false alarm it fixed itself
Hi Luc! Ive been running your .92 firmware for davinci 1, for around 4 years without issue, love it! I recently had to replace my bed, and unfortunately thermistor. I have completely forgotten all my firmware settings from when I initially flashed. It looks like Ill need to build a new table for thermistor and upload. Is there any way to dump out current firmware so I can use it as a starting point. On voltivo forum, you had helped me with a couple settings as my hotend thermistor kept reporting decoupled, and also something with layer fan. I dont want to lose those, especially since Voltivo forum is no more. I know you probably havent messed with this in awhile and probably dont want to, but could you please help a brother out on uploading a new thermistor table without losing all my current tweaks? Thank you so much!
all your settings are in EEPROM so use repetier host to export them , I am afraid dumping FW won't help for a new thermistor - I do not remember layer fan discussion sorry (oXvXo) - unfortunatly I am afraid there is no way than reflash to update thermistor table - or may be to do some reverse engineering on FW but parsing binary FW is not my best skill sorry ...
Luc, You dont remember our conversation from four years ago? Im hurt! ;) Thank you very much for your reply, I had completely forgotten about repetier host as I just upload prints to SD card. Ill wire this thing up and see if I can find the settings I tweaked initially. Ive been running this thing for 4 years almost non stop with your firmware, no issues ever. My bed finally clamshelled to the point where I dont have a spot on the bed without a chip on it. :(
You can use existing FW and change Bed thermistor , bed temperature does not need to be super accurate but constant
so you just need to find the new temperature
fake temperature setting that allow you to reach your previous bed temperature
heat your bed using printer menu and try to heat at 50 degres
then do bed temperature measurement with external thermistor or temperature gun
bed should be around 90 / 110 degres for ABS - so try to see which
fake temperature setting allow you to reach this real value
Thanks Luc, youve always been super helpful, even to those like me that just mash things together without fully understanding what they are doing! I had completely forgotten about being able to tweak firmware settings in rep host. I may not pull this off the right way, but im pretty sure Ill be able to fake it enough to offset the new values. You are very much appreciated!
how about new repetier fw?