These are chat archives for machinekit/machinekit

Apr 2017
Apr 10 2017 01:26
Ah ha! Don't declare those direction pins as "output" pins in the hal file, the stepgen must do it already
removed them from output, success!
Apr 10 2017 07:20
So this was not cramps default config then?
I thought - Oh it seems source of problem is stepper driver. Maybe it pulls low/high too much?
Apr 10 2017 14:46
config issue
don't list the output ports for step and direction in the hal file
Apr 10 2017 14:53
my issue happened even before i had stepper drivers hooked up