These are chat archives for machinekit/machinekit

10th
Sep 2017
Dipl.-Ing. Raoul Rubien, BSc
@rubienr
Sep 10 2017 14:39
Hi @all! I am implementing a module for the xhc whb04b-6 jog dial and have some remaining questions regarding halui pins. First of all is this channel adequate for that kind of questions?
Dipl.-Ing. Raoul Rubien, BSc
@rubienr
Sep 10 2017 14:47
Ok since it will take time until the response comes, i'll just put my question into the room. :)
I am focusing on the jog dial's buttons "W-HOME" and "M-HOME", which I understand as "go to machine/workpiece home". If this is correct, which halui pins are to be connected? I see there is "halui.home-all", but no further for "W-HOME". Thus I believe my assumption about this two buttons must be wrong.
What should the functionality of this two buttons "W-HOME" and "M-HOME" be?