Hi, I'm trying to connect groove temperature and humidity sensor following the link "https://github.com/prafullawadaskar/aws_starter_sdk/wiki/Marvell's-AWS-IoT-Starter-Kit-to-Interface-Grove-Sensors", but I'm getting error as "make SEN_TH=y
make[1]: Entering directory
make[1]: Leaving directory `/home/prashant/aws_starter_sdk'"
make[1]: Entering directory
/home/prashant/aws_starter_sdk'
make[1]: Nothing to be done forbuild'.make[1]: Leaving directory `/home/prashant/aws_starter_sdk'"
What is the solution??
And I checked the code but not getting where the GPIO pins are defined... for example I want to toggle red LED on button push, where do I define that LED in C source file...?? Please help
@Prashant-Kmr which aws_starter_sdk have you cloned ? the one from marvell-iot or one from prafullawadaskur's github page ?
The one from Marvell-Iot @anujdeshpande
No, sorry. I cloned aws_starter_sdk from prafullawadaskar's github page...
@Prashant-Kmr can you give me the output of
cat .git/config
@anujdeshpande cat .git/config
[core]
repositoryformatversion = 0
filemode = true
bare = false
logallrefupdates = true
[remote "origin"]
fetch = +refs/heads/:refs/remotes/origin/
url = https://github.com/prafullawadaskar/aws_starter_sdk.git
[branch "master"]
remote = origin
merge = refs/heads/master
[core]
repositoryformatversion = 0
filemode = true
bare = false
logallrefupdates = true
[remote "origin"]
fetch = +refs/heads/:refs/remotes/origin/
url = https://github.com/prafullawadaskar/aws_starter_sdk.git
[branch "master"]
remote = origin
merge = refs/heads/master
Do I need to set MQTT client before loading sensor program??
@Prashant-Kmr you don't have to set the client in the code. If you mean your AWS thing details, those are supposed to be set once you upload your application code to the board, reboot, connect to the uAP and then go to
192.168.10.1
If you have cloned from Prafulla's repo, you should be able to run make with the right flags depending on your sensor.
if you want to make changes to the pre configured pins, you should take a look at this folder
https://github.com/prafullawadaskar/aws_starter_sdk/tree/master/wmsdk/external/sensors
https://github.com/prafullawadaskar/aws_starter_sdk/tree/master/wmsdk/external/sensors
this is where all the sensor drivers reside
Ya I did the same and it is working but showing 0 values for both temperature and humidity
which pins should I connect for the T&H sensor??
@Prashant-Kmr are you not using the shield ?
I'm using the shield but I'm not getting whether I have connected to correct pins
followed pin connection as in https://github.com/prafullawadaskar/aws_starter_sdk/wiki/Marvell's-AWS-IoT-Starter-Kit-to-Interface-Grove-Sensors
but not getting which pins must be used for only temperature and humidity sensor??
Connected sensor but values not showing for temperature and humidity