hey guys (and especially @ecc1 :D ). I'm trying to update my loop rig to PI0 + rfm69 along with the go implementation. I compiled the medtronic package and mdt and sniff. But I'm not sure with the wiring since I found no hint what pins should be used. I tried to figure it out from the code and came up with SPI+EN0+GPIO23. But it's not working and I'm stuck now.
First I tried the sniff cmd with:
$ ./sniff 13:12:25.422805 connected to RFM69HCW radio on /dev/spidev0.0 13:12:25.422898 setting frequency to 868.000
but it runs forever, although there is communication between the old rig and the pump + the enlite sensor... After 15 min or so I tried the mdt command:
$ ./mdt model 2018/06/02 15:13:37 connected to RFM69HCW radio on /dev/spidev0.0 2018/06/02 15:13:37 setting frequency to 868.000 2018/06/02 15:13:39 waking pump 2018/06/02 15:13:52 no response to wakeup
Any suggestions ?
openaps use pump mmtuneI get the error that it's an invalid choice... Just fyi I didn't flash this c111, I sent it off and someone else did a long time ago. It was working for a bit with my old rig.
@naboull1 from the schematic ( https://github.com/EnhancedRadioDevices/Explorer-HAT/blob/master/Rev%20B/Schematic/Explorer%20Board%20HAT%20Rev%20B%20Schematic.pdf ) you can see they are connected to the CC1110 pins P2_3 and P2_4.
It looks like the firmware ( https://github.com/ps2/subg_rfspy ) uses D4 for a radio diagnostic and D3 for a UART diagnostic.